SUPERFLUID V0.8 (2021-10-08) tlr
    - added a nicer startup/menu screen
    - cleaned up screen setup to reduce various glitches during startup
    - added small delay on reset to simplify startup key combinations
    - only initialize certain parameters on power on, like current device
      number
    - "Z" zero filling and "C" configuring now also clears color ram at
      $DBE8-$DBFF
    - much improved parsing and error checking in the monitor
    - bytes can now optionally be expressed as a single hex digit.
      (based on suggestion for 'L "<file>" 8' by RHX/Excess)
    - added command "TR" transfer reverse which moves data _to_ the
      source range _from_ the destination instead of the normal direction.
    - added monitor prefix '!' to measure execution time of a command.
    - space in the monitor now pauses scrolling. (suggested by RHX/Excess)
    - pressing C= in the monitor holds scrolling while depressed
    - IEC devices 8-15 are now selectable using '@'
    - IEC devices 8-15 are useable as monitor targets
    - prevent user from setting an out of range device number
    - compatibility improvements to the disk turbo
    - cia type detection at startup added
    - improved drive detection, remembers the last drive detected at
      a specific dev num
    - fixed behaviour of reset freeze vs normal freeze such that the
      $0000-$0FFF area is swapped back correctly when needed.
    - improved freeze backups removing a few cases where generating the
      binary would be unsuccessful
    - cleaned up a lot of zeropage handling to avoid collisions with
      basic
    - The Nordic Replay .crt is now built with hw revision 1 as supported
      by vice as of r36850 (thanks to groepaz for implementing it).
    - [BUG] sometimes the drive status message would be blank after reading
      drive ram in the monitor, fixed!
    - [BUG] wrapping of ranges, e.g "T FFF0 0010 0800" only worked
      randomly.  Now fixed!
    - [BUG] some subtle problems with REU address ranges fixed.
    - [BUG] "'" write back interpret wouldn't allow writing chars over
      certain byte combinations, now fixed!  (reported by RHX/Excess)
    - [BUG] freezing with in the menu would crash on "X", fixed.
    - [BUG] sector load/verify/save variants didn't check for missing
      parameters so doing "L 08" would load sector data to some random
      address, fixed!
    - [BUG] write frozen IO '-' would allow arbitrary adresses, messing
      stuff up, fixed!
    - [BUG] write frozen IO '-' would be allowed even if not frozen, fixed!
    - [BUG] quote mode wasn't disabled in the monitor, fixed!
    - [BUG] go 'G' would not work correctly from the frozen state, fixed!
    - [BUG] fixed the default state of CIA timer latches on entering basic.