| |
ready.
Registered: Feb 2003
Posts: 441 |
Release id #41287 : UDPSlave 0.91
hello,
I just got a retro replay + RR-NET cartdrige. I tried the UDPSlave, but after I give RUN I get:
?DEVICE NOT PRESENT ERROR
I loaded the UDPSlave without the fast loader enabled (normal reset option)
If I load it from the fastload, the program seems to hang after giving:
OK
of course RR-NET is plugged in then clock port of the retro replay.
Any ideas?
regards,
Ready. |
|
| |
Devia
Registered: Oct 2004
Posts: 401 |
UDPSlave printing "OK" basically means it detected your RR-Net. From there it goes into a loop where it is waiting to receive a packet.. I never tried it, but that's what it looks like quickly browsing through the src.
I'm guessing you need to poke in some IP/MAC addresses somewhere though, before it responds to anything!? - Did you read the doc?
|
| |
yago
Registered: May 2002
Posts: 333 |
i am using (rrnet-builtin) codenet to transfer most of the time, and netmon otherwise.
netmon is based on udp-slave
however, i need to start netmon 2-3 times (on c64) to get it running, maybe its a bug inherited from udpslave..
to check if your network is configured properly, codenet (start with F6) has ping builtin
hope this helps
|
| |
chatGPZ
Registered: Dec 2001
Posts: 11386 |
its not rr-net builtin though =P |
| |
yago
Registered: May 2002
Posts: 333 |
s/rrnet-builtin/tfr-builin/ |
| |
MagerValp
Registered: Dec 2001
Posts: 1078 |
UDPSlave should respond to pings when it's at the OK prompt. The homepage shows you how to set the IP address and has a few troubleshooting tips:
http://www.paradroid.net/udpslave/ |
